Download  Print this page

Customer Assistance - Honeywell CT3200 Owner's Manual

Programmable
Hide thumbs

Advertisement

If...
Heating does not come on
Cooling does not come on
The house is too warm or too cool
Furnace cycles too often or system
cycle length is too short or too long
The thermostat current setting does
not match the display temperature to
within plus or minus 1°

CUSTOMER ASSISTANCE

Visit us on the Web at www.honeywell.com/yourhome or call Honeywell Customer Care at 1-800-468-1502.
Before you call, please have the following information available:
Thermostat model number and serial code (located under the battery cover).
Type of heating/cooling system (hot water, warm air, oil, gas, etc.).
Number of wires connected to the thermostat.
NOTICE: This equipment is a Class B digital apparatus, that complies with Canadian Radio Interference Regulations, CRC c.1374.
Check that the System switch is set to Heat.
Check the system fuse or circuit breaker and replace or reset if necessary.
Check for correct wiring and good connections.
If display is blank or displays "bAt Lo," install fresh batteries.
Allow time for the furnace to heat up and the fan to come on before
checking for heat at the register.
If temperature setting is higher than current room temperature and
SYSTEM ON arrow is displayed, thermostat is operating correctly. Contact
heating contractor for assistance.
Check that the System switch is set to Cool.
Check the system fuse or circuit breaker and replace or reset if necessary.
Check for correct wiring and good connections.
If display is blank or says "bAt Lo," install fresh batteries.
The thermostat has a built-in time delay on cooling. Allow 5-10 minutes
after changing setting before air conditioner starts.
If temperature setting is lower than room temperature and SYSTEM ON
arrow is displayed, thermostat is operating correctly. Contact ac contractor.
Press RUN PROGRAM to check the current temperature setting.
If desired, change the temperature setting.
Adjust the screws on the back of the thermostat.
Plug the wiring hole in the wall behind the mounting plate with insulation to
prevent drafts that might adversely affect thermostat operation.
Be aware that it is normal for the current setting and the displayed room
temperature to differ on occasion.
During recovery from setback or setup, setting and displayed room
temperatures can differ for up to 30 minutes after recovery period.
23
Then...
69-1631—1

Hide quick links:

Advertisement

loading

  Related Manuals for Honeywell CT3200

This manual is also suitable for:

32002418Ct3200 series