Honeywell CT3200 Owner's Manual page 3

Steam
A steam boiler with radiator heat.
Heat Pump
Heating and cooling are produced from the same outdoor unit (compressor) with
no auxiliary or backup heat.
Multistage Heat Pump
Heating and cooling are produced from the same outdoor unit (compressor) with
auxiliary or backup heat.
Multistage Conventional
A heating or cooling system with more than one stage.
Step 1. Prepare for Installation
1. Carefully unpack your new thermostat. Save your receipt and make sure you have the following parts:
• Thermostat and mounting plate
• Labels
• Screws and anchors
• Installation and Programming Instructions
2. Gather the needed tools and supplies listed below.
Required Tools and Supplies
• Two AA alkaline batteries. Honeywell recommends Energizer®
batteries.
• Screwdriver.
• Hand or power drill with 3/16-inch or 7/32-inch drill bit.
• Pencil.
3. Make sure that your heating and cooling systems are working properly. If there is a problem with either system,
call a heating/air conditioning contractor—the problem may persist after you install the new thermostat.
IMPORTANT:
To avoid damaging the compressor in the air conditioner, do not operate the cooling system when the tem-
perature outdoors is below 50°F (10°C).
Heating/Cooling System
• Wire cutter/stripper or sharp knife.
• Level.
• Electrical tape.
3
Compatible
with CT3200? Alternate Model
No CT3600
No CT3600
No CT3611
No See your
contractor
Optional Tools
69-1631—1