Hitachi C 10FL Instruction Manual page 13

ASSEMBLY THE TABLE EXTENSION (Fig. C)
Place the left table extension next to the saw table,
1.
aligning the mounting holes (1).
Place bolts (2) and thread in mounting holes.
2.
Place a straight edge or combination square on the
3.
saw table, across the table extension.
Adjust the mounting bolts (2) until the extension is
4.
flush with the saw table. Tighten.
Repeat these procedures for the right extension table.
5.
Fig. C
2
ASSEMBLY THE FRONT AND REAR TABLE RAIL
(Fig. D, E)
NOTE: Front of table rails assemblies are different.
Assembly the front rail (Fig. D)
Attach the right front side cover (1) into right front
1.
table rail (2). Repeat for the left front rail.
Place the hex. bolts M8-20 (3), hex bolts M8-16 (4)
2.
through the holes at the front table edge. Screw the
square nuts (5) onto each bolts.
NOTE: Keep the bolts and square nuts loosened
before front rail fixed.
Attach the right front rail onto proper location by
3.
having the square nuts pass through the slot of the
front rail. Repeat for the left front rail.
Attach the middle plug (6) to connect the two half
4.
front rail. (Fig. E)
When the blade was installed, use the rip fence and
5.
gauge to adjust the front rail to proper location. When
the front rail is level with table, then fix the front rail
by tightening the six bolts.
Fig. D
5
4
6
Assembly the rear table rail (Fig. E)
6.
7.
8.
Fig. E
1
BLADE RAISING HANDWHEEL (Fig. F)
Thread the blade handwheel handle (1) into blade raising
handwheel (2) and tighten.
BLADE TILTING HANDWHEEL (Fig. F)
1.
2.
Fig. F
BLADE GUARD ASSEMBLY (Fig. G, H)
3
4
To avoid injury from an accidental start, make sure the
switch is in the OFF position and the plug is disconnected
from the power source outlet.
2
1
13
— —
Attach the side covers (1) and middle plug (2) to the
rear table rails (3).
Place the rear table rails on the saw table, aligning
with the holes in each rail.
Place the bolts (4) and tread in the holes; tighten the
bolts and check the alignment again.
Attach the blade tilting handwheel (3) to the elevation
screw at the front of the saw.
Attach and tighten the dome nut (4) at the end of the
shaft.
2
1
3
WARNING
When installing the blade guard, cover the blade teeth
with a piece of folded cardboard to protect yourself
from possible injury.
Never operate this machine without the safety guard
in place for all through sawing operations.
4
3
1
2
4