Menu Button - Hitachi LE46S605 Owner's Manual

How To Use The Remote Control To Control Your TV
Closed Captioning will display automatically when MUTE is
on and Closed Caption is set to With Mute (See page 41).
When the TV power is turned off at a volume level 21 or
greater, the volume level will default to 20 when the TV
is turned on. However, if it is set to a level 20 or less, the
volume level will be at the level it was set when the TV was
turned off.

MENU Button

7
The MENU button will start the On-Screen Display.
EXIT Button
8
This button will exit all On-Screen Displays.
CURSOR PAD/SELECT Button
9
All the On-Screen Display features can be set or adjusted
by using the CURSOR PAD and the SELECT button,
except for numeric entries. Press the CURSOR PAD toward
desired direction and press the SELECT button to select.
INFO Button
10
Press this button when you want to check the channel being
received, the picture source, if the channel has stereo (ST)
or second audio program (SAP), the time, and CHANNEL
ID.
ANALOG CHANNELS
INFO
No Program Title.
No Program Description.
Program Information
DIGITAL CHANNELS
INFO
Sesame Street
Program Description.
Program
Program Information
Run Time
VIDEO INPUTS
INFO
No Program Title.
No Program Description.
Program Information
Main Picture Source
ATV
& Channel Indication
39-0
Clock
3:17PM
Broadcast Rating
TV-G
Analog Audio Broadcast
Stereo+SAP
Analog Channel
Main Picture Source
DTV & Channel Indication
15-1
Broadcast Channel
KPBS-HD
Indication
Clock
3:17PM
3:00PM- 3:30PM
Broadcast Rating
TV-G
1080i Multi
Audio Broadcast
Picture Format
Main Picture Source
HDMI
Clock
3:17PM
1080i
Picture Format
• Press the INFO button again or the EXIT
NOTES
button to return to normal viewing.
• The Aspect INFO will not be shown when
the INFO button is pressed.
GUIDE Button
11
Press this button to access the Channel Guide of your
satellte receiver, set top box or cable box while in SAT/CBL
mode.
INPUT Button
12
Press this button to access the INPUTS menu. Use the
CURSOR and SELECT buttons to select the desired
input. Pressing the INPUT button repeatedly will also
cycle through the inputs that are available. Then press the
SELECT button or wait 4 seconds to automatically select
the highlighted input.
+
Input List
0. TV
1. HDMI 1
2. HDMI 2
3. HDMI 3
4. Component
5. AV
6. RGB
/ INPUT Move SEL / 0 - 6 Select
0. TV Watch TV from an Air or Cable signal.
1. HDMI 1 Select to choose HDMI 1 Input.
2. HDMI 2 Select to choose HDMI 2 Input.
3. HDMI 3 Select to choose HDMI 3 Input.
4. Component Select to choose Component Input.
5. AV Select to choose AV Input.
6. RGB Select to choose PC input
• Depending on the device, it may be
NOTES
required to turn on the device for the
TV to recognize it is available. You can
access these inputs by using the cursor
or number buttons on the remote control.
• When Y-PbPr on VGA is set up as
Component 2 (Refer to page 17), the RGB
input in the Input List will be automatically
replaced with Component 2.
+
21