Table of Contents
Advertisement
Equipment Care And Troubleshooting
DO
•
Dust the screen and cabinet with a soft cloth.
•
Clean the screen with a soft cloth moistened in warm
water and dry with a soft cloth. A mild soap may be used if
the screen is extremely dirty.
•
Place your LCD Television away from extreme heat,
humidity and extremely dusty places.
•
Remove the plug from the wall outlet if your LCD Television
will not be used for a long period of time, for instance,
when you go on vacation.
Troubles are sometimes caused by simple "faults" that you can correct without the help of a service technician.
If you experience any difficulty with your TV, check a few basic remedies before calling your service technician.
TV will not turn ON
1. Press the POWER button (ON/OFF button) once.
2. If there is still no power, wait 30 seconds and press the POWER button again.
3. If there is still no power, unplug the power cord from the wall. Wait 30 seconds and plug the power cord back in. Press the
POWER button again.
When the Following Messages Appear on the Screen
Message
No Signal
Symptom and Checklist
SYMPTOM
No picture - no sound
Multiple images-normal sound
Intermittent interference
Normal picture, but no sound
DO NOT
•
Do not clean your screen with strong cleaners, polishes or
a chemically treated cloth.
•
Do not place rubber or vinyl products or tape on your LCD
Television.
•
Avoid repeatedly touching the screen.
•
Do not drop or hit the remote control. This may cause
internal damages.
•
Avoid placing the remote control in a high humidity place
or getting it wet. Do not leave it on or near a heater.
Excessive heat or moisture may cause the unit to fail.
•
When the batteries run down, remote control operation
will become erratic or become unresponsive. Replace the
old batteries with two new "AAA" size batteries. Do not
use an old battery with a new battery.
•
Exposing the screen to direct sunlight for a long period of
time or heat may cause damage to the LCD screen.
•
Do not spray any cleaners directly onto screen.
Condition / Action
The unit cannot detect any signals from any input jacks or the TV
channel does not show picture.
•
Check if the cable is connected correctly and firmly.
•
Check if the power of any external device is ON.
•
Check if the input selection matches the connection jack.
•
This message will be displayed for 15 minutes then the TV will turn
off.
CHECKLIST
•
Check the indicating lamp status (Off, Red, Blue).
•
Check the connection of the power cord and/or other cables.
•
Check if the power of the unit or external device is ON.
•
Check if the correct Video input is selected.
•
Check if the unit is in "Standby mode".
•
Adjust the values in "Video menu" and "Audio menu".
•
Check the connections to external device.
•
Check if the source of interference is shielded correctly.
•
Move these kinds of electrical devices away from the unit.
•
Check the volume level.
•
Check if the MUTE button has been pressed or not.
•
Check the connections to external device.
•
Try next/other Audio Language.
PAGES
9,
12,
15~19,
32~37
15~19
51
15~20, 36
49
Hide quick links:
Advertisement
Table of Contents
