Fan Only Operation - Haier Unitary smart series Service Manual

[FAN] [HIGH] high fan speed
[FAN] [MED] medium fan speed
[FAN] [LOW] low fan speed
[FAN] [FIX] fixed fan speed, it will display only when fixed fan speed is requested to main
indoor unit.
[CENTRAL] central control mode
[OPERATION] running mode
[STAND BY] waiting mode
[PRE-HEAT] pre-heating mode
[DEFROST] defrosting mode
[FILTER] request of filter to be cleaned
[HEALTH] health function
[UNIT NO.]
[CEN.ADD] central control address, the address number will display on "88
[SYS.ADD.] system address, the address number will display on "88
[CHECK] auto-diagnostic, trouble shooting
[DEMAND] compulsory operation function, when it works, [CENTRAL] will flash
[SWING] swing mode
[ROOM TEMP.] indoor ambient temperature
[SET TEMP.] set admired temperature.
[TIMER][ON] timer function is on.
[TIMER][OFF] timer function is off
[TIMER][ON][OFF]
[TIMER][ON][OFF][DAILY] timer ON-OFF will switch over in turn daily
[CLOCK] clock display, the displaying time is the current time of the clock.
[UP] [DOWN] indicator of filter elevating
[VENTILATION][AUTO] auto ventilation mode
[VENTILATION][RECOVERY] fully heat exchanging ventilation mode
[VENTILATION][NORMAL] normal ventilation mode

FAN ONLY OPERATION

1 Start up operation: press the button of ON/OFF, the system will start up, and will display
[MODE][AUTO] [FAN][AUTO] [ROOM TEMP.]+ 24
2 Select MODE: press the MODE button, then you will see in the display section [MODE]
switch over in below sequence:[FAN ONLY]
[FAN ONLY]. Select [FAN ONLY].
3 Select fan speed: press FAN button, then you see in the display section [FAN] switch over
in below sequence: [HIGH] [MED] [LOW] [HIGH]. Select proper fan speed.
4 Power off: press ON/OFF button, indoor unit will be powered off, there are only time and
the ambient temperature in the screen.
timer function ON-OFF
a__WcU S^
[CLOCK]+"12 00".
[COOL] [DRY] [HEAT]
c a`V e a`Wc
[AUTO]