Sanyo SAP-K9AP Instruction Manual page 14

4. OPERATION OF WIRELESS REMOTE CONTROL UNIT
4.5 Using the SLEEP Operation
In Cooling and DRY
Mode : ( and
4.6 Using of the "Special"
Features
"DRY"
Operation
How it works?
"AUTO"
Operation
How it works?
"BLOW"
Operation
How it works?
Operation and Maintenance
SLEEP Mode is used for saving energy.
)
Press the SLEEP button while operation.
The
To release the SLEEP function, press the SLEEP button
again.
When the SLEEP mode is selected, the air conditioner
automatically rases the temperature setting 1 °C when 60
minutes have passed after the selection was made, and
then another 1 °C after another 60 minutes have passed,
regardless of the indoor temperature when SLEEP was
selected. Afterwards, the unit will remain this temperature.
This enables you to save energy without sacrificing comfort.
This function is convenient when gentle cooling is needed.
• While DRY operation, fan speed is automatically set to LOW.
• If the room temp. is 2 °C higher than the Set Temperature,
the unit will run in COOL mode.
• Once the room temp. reaches ± 2 °C of the level that was set,
the unit repeats the cycle of compressor turning "ON" 6 mins
and turning "OFF" 4 mins automatically.
• When AUTO mode is selected, the default temperature will be
displayed on the LCD, the unit will be in accordance with the
room temperature automatically to select the suitable running
method and to adjust ambient comfortable.
This function indicates that moisture on evaporator of indoor
unit will be blowed after the unit is stopped to avoid mould.
Once blow function is on, while the unit is off by pressing the
ON/OFF button, the indoor fan will continue running for about
10 min. at low speed. In this period, press "BLOW" button
again can stop indoor fan directly.
mark appears in the display.
Setting
temperature
1 °C
Press the 60 min.
SLEEP button
1 °C
60 min. Time
12