Sanyo SAP-K9AP Instruction Manual page 18

5. CLEAN AND CARE
5.2 Cleaning the Air Filters (Continued)
1. Take Down the Air Filters
Pull out the panel to an angle at botttom grooves on
panel. And, pull the air filter upward then downward
to take it off. (Fig. 7).
2. Cleaning
To clean the dust adhering to the filters, you can
either use a vacuum cleaner, or wash them with
warm water (the water with the neutral detergent
should below 45 C) when the filters are very dirty
(such asoil stain), and dry it in the shade. (Fig.8)
Don't use hot water which temperature
NOTE
is above 45°C to prevent fade or
deformation.
Don't dry it on fire for filter, it would
catch a fire or deformation.
3. Put back the filter
Put back the filter, then cover the surface panel well.
(Fig. 9)
5.3 Check Before You Use
1. Be sure that nothing obstructs the air outlet and
intake vents. (Fig.10)
2. Check that whether ground wire is properly
connected or not.
3. Check that whether the batteries of air conditioner
are changed or not.
4. Check that whether installation stand of the outdoor
unit is damaged or not. If damaged, please contact
the dealer.
5.4 Maintain After Use
1. Turn main power off.
2. Clean the filter, indoor and outdoor units' bodies.
3. Clear dust and obstructions from the outdoor unit.
4. Repaint the rubiginous place on the outdoor unit to
prevent it from spreading.
Operation and Maintenance
o
Fig.7
air filter
Fig.8
Fig.9
Fig.10
16