Wash System - Haier ESD400 Service Manual

Serial Number: Version:00.00 Edition: Nov.-23-2005
Built-In Dishwasher
Model: ESD400/ESD401/ESD402
After the first time that you use delay, the control will start by calling up the last delay that you can. You can adjust from
there if you want to change it.
To delay the start
1.Close the door.
2.Repeatedly press until you see the desired hours of delay in the display.
When the delay reaches 12 hours, the delay turns off. Press Delay Start again to select a new number of delay hours.
3.Select a wash cycle and options.
NOTE: To cancel the delay and cycle, press Cancel .To cancel the delay and start the cycle immediately, press Delay
Start until no hours show in the display.
Plate Warmer
Use the Plate Warmer option to warm serving dishes or dinner plates.
Note: Do not use the option with cycles.
1.Open the door
2.Press plate warmer button, plate warmer glows.
3.Allow 8 minutes to heated the dishware.
10.7 Cycles Status Indicators
Follow the progress of your dishwasher with the Cycle Status indicators.
Water Heated (on ESD310/311/312 models)
Water Heated glows only when the cycle pauses to heat water to a set temperature .Washing or rinsing continues as
water
heated. Once water reaches the set temperature, the light goes off and the cycle resumes.
Washing (on ESD310/311/312 models)
Washing glows during prewash and main wash periods.
Turbidity Sensor (on ESD310/311/312 models)
Turbidity Sensor glows during the sensing part of the cycle. Your dishwasher sense soil lever at the end of the Pre-Wash.
Washing continues while Sensing occurs.
Rinsing (on ESD310/311/312 models)
Rinsing glows during rinse periods.
Drying (on ESD310/311/312 models)
Drying glows when the dishwasher is drying after the final rinse.
Clean
Clean glows when a wash cycle is complete. The light will remain ON until door is opened.
Sanitized
Sanitized glows when cycle has met sanitization condition. The light will remain ON until door is opened.
Add Rinse Aid (on ESD310/311/312 models)
Fill the Rinse Aid dispenser when Add Rinse Aid is lit. A rinse aid prevents water from forming droplets that dry as spots or
streaks. If the Rinse Aid dispenser is empty, the light glows when you select a cycle or while a cycle is running.

11.Wash System

The five-level wash system provides excellent cleaning results. Three levels
of filtration and a Soil collector system filter the wash water and prevent food
Page 36 / 48