Advertisement
(3) Cut off the OE injector harness connectors and
replace with Kit injector harness connectors.
※
Mark or label harness wires to ensure that they are
connected to the proper pin on the injector.
※
Do not connect the injector connector at this time.
３－10 OE Engine Wire Harness
(1) Split the OE Wire harness in this way: A – alternator
B+ wire, B – alternator connector, C – A/C
compressor, D – knock sensor, E – crank position
sensor. Wrap the wires with the provided colgate
tubing.
※
Combine the knock sensor and crank position sensor
wire harness into the same colgate tube.
※
Cut the colgate tube to the proper lengths and tape
then ends of the tubing with electrical tape.
(2) Connect
the
alternator connectors and use cable ties to secure
wires.
Connect
connectors.
※
Route the alternator B+ wire in front of the
supercharger and connect to alternator.
sensor
harness
connectors
engine
harness
〈Parts №１７，１８〉
Solder procedure
① Remove sleeve
③ Solder wires
Double check connections
Ｃ
Ｄ，Ｅ
〈Part №１９〉
and
to
injector
―１０―
② Wrap wires together
④ Wrap with electrical tape
Ａ
Ｂ
Ｂ，Ｃ，Ｄ，Ｅ
Ａ
Advertisement
