2003 infiniti g35 coupe (vq35de) twin td05-18g 8cm2 (23 pages)
Summary of Contents for GReddy TYPE-RS BRS-307 D32
Page 1
BRS-307 BRS-307 BRS-307 BRS-307 D32 D32 D32 D32 Instruction Manual Instruction Manual Instruction Manual Instruction Manual Please read the manual carefully before installing and using this Please read the manual carefully before installing and using this Please read the manual carefully before installing and using this Please read the manual carefully before installing and using this product.
SAFETY INFORMATION SAFETY INFORMATION SAFETY INFORMATION SAFETY INFORMATION Important Important Important Important This Manual will explain the proper installation procedure of this product. ○ Please read this manual carefully. ○ This manual was created considering the vehicle to be completely factory spec. ○...
Page 3
GReddy Performance Products, Inc. GReddy Performance Products, Inc. GReddy Performance Products, Inc. GReddy Performance Products, Inc. 3- -...
Installation Installation Disconnect the vacuum hose, recirculation hose and remove the factory air bypass valve. Mount the GReddy Blow Off Valve<No.1> on to the supplied adaptor<No.2> using the provided gasket<No.5> and hardware <No.7>. Remove the rubber sleeve off from the factory bypass valve and install it on to the GReddy Blow off valve adaptor.
Page 5
Remover the plastic pipe out of the factory suction pipe and install the provided aluminum plug<No.4> with factory hose clamp. Install the GReddy Blow Off Valve as shown using the factory hose clamps. Reconnect the vacuum using the factory hose clamps.
Starting the engine Starting the engine Starting the engine Starting the engine (1) Inspect the installation. Reconnect the negative terminal of the battery and start the engine. (2) Check and make sure that there no air leeks, clearance problems or irregular sound. (3) Lightly rev up the engine couple times to check if the blow off valve is operating.
Page 7
How to change the Attachment How to change the Attachment The attachment on the GReddy Type RS is interchangeable with discharge funnel or hose attachment. To remove the attachment, turn it counter clock wise, and to install turn it clock wise.