Channel Level P - Goldmund SRDVD MULTIFORMAT PLAYER User Manual

P 44 |
User manual - GOLDMUND SRDVD MULTIFORMAT PLAYER
3
O P E R AT I N G T H E S R D V D
3 . 9
T H E I N I T I A L S E T T I N G S M E N U
C L
HANNEL EVEL
• Default setting: Fix
You only need to make this setting if you connected this player to your amplifier using the 6
channel analog outputs.
This setting does not affect digital audio output.
When set to Fix, the level of each of the 6 channel analog outputs is fixed.
Choose Variable if you want to adjust the relative levels to balance the surround sound better
for your listening room.
You can set the individual channel levels between –6dB and +6dB using the test tone output as
a guide to set the correct levels.
Adjust the levels until the output level from all channels sounds the same from your usual
listening position.
Automatic: Select Auto to start the test tone output.
As the test tone plays through each speaker in turn, it is highlighted on-screen.
Use the cursor up/down buttons to adjust the channel output level of the current speaker.
Note that the test tone is not output from the subwoofer.
Press (cursor left) to exit the test tone sequence, or ENTER to save the settings and exit the
channel level setting screen.
Manual: Use the cursor up/down buttons to select a speaker. Press (cursor right) then use the
cursor up/down buttons to set the channel output level.
To turn the test tone on/off for an individual speaker, press (cursor right). The test tone
continues playing even when you select a different speaker.
Press ENTER to save the settings and exit the channel level setting screen.