Speakers P - Goldmund SRDVD MULTIFORMAT PLAYER User Manual

Note: Even if you set Audio Output Mode to 5.1 Channel,
you'll only get sound from all speakers when playing a
multichannel DVD-Audio disc, SACD, or Dolby Digital or DTS
encoded DVD disc.
- When set to 5.1 Channel, only the front left/right
channels are output from the AUDIO OUT (2ch) jacks.
Change to 2 Channel if you want to listen to downmixed
stereo audio (for example, because you are listening
through the TV's built-in speakers).
- When set to 5.1 Channel there is no digital output when
playing DVD-Audio.
- If you set to 2 Channel, Dolby Digital, DTS and MPEG
audio is mixed down to
two channels so you still hear all the audio recorded on
the disc.
- Some DVD-Audio discs don't allow down-mixing of
audio. These discs always output multi-channel audio
regardless of the setting made here.
Note: You can see the effect of your changes in the
room graphic on the right of the screen.
- Except for the subwoofer, you can set speaker size to
Large or Small. If the main speaker cone in the speaker
is 12cm or more, set to Large, otherwise set to Small (or
Off if you don't have that speaker).
- If you set the front L and R speakers to Small, the center
and surround speakers are automatically set to Small and
the subwoofer to On.
- The subwoofer can only be set to On or Off.
Note: When listening to a DVD-Audio or DTS source,
the C, LS, and RS speakers will automatically be set
to the Large size setting. However, the sound will not
be affected by the change. Listening to another
source will return the speakers to their original
settings.
- For DVD-Audio only, if the C, LS, or RS speaker is set to
Off, the audio is automatically down-mixed to stereo.
3
O P E R AT I N G T H E S R D V D
3 . 9
T H E I N I T I A L S E T T I N G S M E N U
SPEAKERS
Audio Output mode
• Set in Setup Navigator (Default: 2 Channel)
If you connected this player to your amplifier using the 6 channel analog outputs (front,
surround, center and subwoofer outs), set this to 5.1 Channel; if you connected only the stereo
outs, set to 2 Channel.
Speaker Installation
• Set in Setup Navigator (default: L/R: Large | C: Large | LS/RS: Large| SW: On)
You only need to make this setting if you connected this player to your amplifier using the 5.1
channel analog outputs. This setting does not affect digital audio output.
Use the Speaker Installation screen to tell the player what kinds of speakers you have
connected.
1 Use the cursor up/down buttons to select a speaker.
Note that the L and R, and RS and LS speakers are paired; you can't set them differently.
2 Press (cursor right) to modify the selected speaker.
3 Use the cursor up/down buttons to change the current setting.
4 Press (cursor left) to go back to the speaker list if you want to modify another
speaker, or press ENTER to exit the Speaker Installation screen.
User manual - GOLDMUND SRDVD MULTIFORMAT PLAYER |
P 43