Setting The Tv System - Goldmund SRDVD MULTIFORMAT PLAYER User Manual

Note: You have to switch the player into standby
(press STANDBY/ON) before each change.
3
O P E R AT I N G T H E S R D V D
3 . 3
S E T T I N G T H E T V S Y S T E M
The default setting of this player is AUTO, and unless you notice that the picture is
distorted when playing some discs, you should leave it set to AUTO. If you experience
picture distortion with some discs, set the TV system to match your country or region's
system. Doing this, however, may restrict the kinds of disc you can watch. The table
below shows what kinds of discs are compatible with each setting (AUTO, PAL and
NTSC).
1 If the player is on, press STANDBY/ON to switch it to standby.
2 Using the front panel controls, hold down "Forward" then press STANDBY/ON
to switch the TV system.
The TV system changes as follows:
AUTO => NTSC
NTSC => PAL
PAL => AUTO
The player's display shows the new settin
DISC
Type
DVD
Video CD
CD / no disc
Watching NTSC on a PAL TV
Most models of the newly developed countdown PAL TV system detect 50 Hz(PAL)/
60 Hz (NTSC) and automatically switch vertical amplitude, resulting in a display
without vertical shrinkage. If your PAL TV does not have a V-Hold control, you may not
be able to watch NTSC discs because of picture roll. If the TV has a V-Hold control,
adjust it until the picture stops rolling. On some TVs, the picture may shrink vertically,
leaving black bands at the top and bottom of the screen. This is not a malfunction; it
is caused by the NTSC to PAL conversion.
g.
PLAYER SETTING
Format NTSC PAL
NTSC NTSC MOD.PAL
PAL –– PAL
NTSC NTSC MOD.PAL
PAL NTSC PAL
NTSC PAL
User manual - GOLDMUND SRDVD MULTIFORMAT PLAYER |
AUTO
NTSC
PAL
NTSC
PAL
NTSC or PAL
P 13