Line Voltage; Connections - Goldmund METIS ONE User Manual

ATTENTION: The Metis One does not
have an input selection switch. Only one
input can be used at once.
3

LINE VOLTAGE

The Goldmund Metis One amplifier is preset at the factory for your country's voltage. It
functions with AC voltages between either, 200V and 245V, or, 95V and 125V.
If your AC line is usually out of these tolerances, please consult your local Goldmund
dealer.
Please check the value of the mains line fuse. This fuse is located in the power cord
receptacle. The lid can be removed with a small screwdriver when the cord is removed.
Use a 3.15A slow-blow fuse.
4

CONNECTIONS

Check if volume control is down to zero on the preamplifier.
You have two possibilities to connect your Universal Power Amplifier:
Connect the analog output of your analog preamplifier to the analog input of the
Goldmund Metis One.
Connect the digital output of your digital preamplifier to the digital input of the
Goldmund Metis One.
Connect the speaker cables to the red and black terminals accessible at the back of the
amplifier.
You may notice that the ground of the input and the black speaker terminal are of the
same polarity. The amplifier is non-inverting in phase.
Then, connect the power cords to the back of the amplifier and plug it in the nearest wall
plug. Use a 3 lugs grounded plug, for safety reasons. To get the best sound of the
amplifier, avoid multiple plugs or extension cords.
GOLDMUND METIS ONE – Universal Power Amplifier - 6