Connections & Line Voltage Adjustments - Goldmund Amplifiers User Manual

Note: A gain selection is available to
raise the global gain
headphone amplifier in case you are
using a headphone with
sensitivity. Please contact your official
Goldmund representative to configure
your unit.
3
CONNECTIONS & LINE VOLTAGE ADJUSTMENTS
Connect the power cord to the back of the integrated amplifier and plug it into the nearest
wall plug. For safety reasons, use only a 3 lugs grounded plug.
To get the best sound from the Telos Headphone, avoid any multi-way plugs or extension
cords.
Connect a computer, CD/DVD or Blu-ray player to the back panel of the Goldmund Telos
Headphone Amplifier, using either the USB Audio, Toslink Optical, RCA Digital or RCA
Analog connector.
A USB driver needs to be installed on your computer before to use it as a source with your
Telos Headphone Amplifier.
Mac and Linux operating system do not need driver to be used with the Headphone
Amplifier.
Please contact your authorized Goldmund retailer to assist you to set up your computer for
use with the Telos Headphone Amplifier.
When the input source is connected, connect your headphone amplifier to your headphone
using one of the two input connector located on the front plate of your unit.
of your
Select one of the 3 available inputs for listening using the front input switch.
a low
Only one connection per input can be used at once. The Optical Toslink input has the
priority on the RCA Digital input, in case you want to use the Digital input, unplug the
Optical cable from the digital input.
AT T E N T I O N:
A residual high frequency noise may remain audible in some circumstances if an analog
input is left open and is selected. This disturbance has no effect on the amplifier but may be
avoided easily through the application of short-circuit plugs on all unused inputs.
User manual – Goldmund Telos Headphone Amplifier - 6 -