Table of Contents
Advertisement
USING THE REMOTE CONTROL
PUTTING BATTERIES IN THE REMOTE CONTROL
(1) To remove the cover, slide it outwards
while pressing it down.
PRECAUTIONS
To prevent malfunction, do not apply any form of severe shock to the remote control. To prevent malfunction or deformation, do not allow
the remote control to become wet and keep it away from hot surfaces or heating equipment. Do not clean the remote control using a cloth
dampened in a volatile solvent, such as benzene or thinner.
EFFECTIVE RANGE FOR THE REMOTE CONTROL
When using the remote control, be sure to point it directly at the plasma display's signal receiver. Make sure that there are no obstacles
between the remote control and the plasma display's signal receiver.
Display – front
Left
CAUTION
It is very important to use replacement batteries of the same type as the originally used. Do not use rechargeable batteries (Ni-Cd, etc.).
When disposing of used batteries, please comply with governmental regulations or environmental public institution's rules that apply in your country/
area.
Note
• The remote control will not function properly if the batteries are dead. Be sure to replace them as needed.
• The remote control may not function properly if a high-frequency fluorescent lamp or the like is used. In this case, move the lamp or use the remote
control from a different position.
(2) Place two AA batteries in the remote
control. Make sure that the batteries are
properly oriented.
Display – side
Right
5 m (Front)
(3) Close the cover until it snaps into place.
Upper
Lower
E-9
Hide quick links:
Advertisement
Table of Contents
