Set Pagebreak - Qlogic SANbox 9000 Series Interface Manual

Stackable chassis switch

Hide thumbs Also See for SANbox 9000 Series:

Table of Contents

Set Pagebreak

Specifies how much information is displayed on the screen at a time. This

command is useful for disabling pagebreaks to allow command scripts to run

without interruption.

pagebreak [state]

[state] can be one of the following:

Limits the display of information to 20 lines at a time. The page break

function affects the following commands:

Allows continuous display of information without a break. This is the default.

Alias (List, Members)

Show (Alarm, Log, Test Log)

Zone (List, Members)

Zoneset (List, Zones)

Zoning (Active, List)

15 – Command Reference

Command Listing