Model 45HEPA TT
HEPA Dry Vacuum for Power Tools
This vacuum cleaner is a high quality, precision made
product. All parts used in the manufacturing of this
vacuum cleaner have passed rigid quality control
standards prior to assembly and an "each unit" ﬁ nal
inspection prior to packaging is your assurance of
proper assembly. This vacuum cleaner was protectively
packaged to prevent possible damage in transit. Should
damage occur, please notify the transporting carrier
immediately for loss and\or claim.
TO CONNECT THE HOSE
Insert the hose end into the tank inlet until it clicks. To
remove the hose, press the button on top of the hose
inlet, and remove hose.
Insert casters into sockets on bottom of canister. Push
casters until seated. Attach hose to coupling on front
This vacuum cleaner contains no user serviceable
parts. If repair is needed, please take the vacuum
cleaner to an authorized Pullman-Holt factory service
FOR DRY PICKUP
Install paper bag on inlet inside of tank. Insert the
HEPA ﬁ lter assembly in the top of the tank. Install
FOR USE WITH POWER TOOLS
For use with power tools drawing 3.9 amps or less.
Turn the vacuum switch off, and connect the power
tool drawing 3.9 amps or less to the outlet in the motor
head. When the power tool is started, the vacuum
Operation & Care Instructions
Save For Future Reference
ABOUT THE MACHINE
cleaner will start. The vacuum cleaner will continue
to run for a few seconds after the power tool is turned
off, in order to clear dust from the hose. When no
power tool is attached, the vacuum cleaner may also
be turned on and off using the switch on the power
Coil cord n a large loop and insert under handle for
storage. Grasp the plug when unplugging from wall.
Do not pull the cord.
Do not use this vacuum to pick up hazardous
materials without HEPA ﬁ lter being installed.
Never lubricate the vacuum cleaner motor. The
motor bearings are permanently sealed. This
vacuum is intended for indoor or outdoor use
and for wet pickup, but it is not intended to be
exposed to rain.