Zenith SYSTEM 3 SY2738RK Operating Manual & Warranty page 20

GEM4000 VCR PLUS+C3® REMOTE CONTROL
VCR PLUS+ CHANNEL MAPPING (Continued)
Changing Default Channel Numbers on Remote
Refer to your completed worksheet on the previous page. You
will key-in the GUIDE CH numbers that need to be mapped to
the TV CH numbers listed in Column 3 on the worksheet.
Follow the instructions below for each channel number that
needs to be mapped.
Steps
1. Press PRG.
2. Press VCR+.
3. Key-in the GUIDE CH
aumber from Column 2 you
need to channel map.
4. Press ENTER.
Remote Display
PROGRAM
GUIDE CH - TV CH
GUIDE CH - TV CH
XXX
GUIDE CH - TV CH
XXX
5. Key-in "IV CH number GUIDE CH - TV CH
from Column 3. x x X Y Y Y
6. Press ENTER.
GUIDE CH - TV CH
7. Repeat Steps 3 - 6 for other channel number mapping.
8. Press ENTER when finished.
XXX,YYY=Your entered information
Channel Mapping Review
When finished Channel Mapping the Guide Channel Numbers
to your TV Channel Numbers, follow the instructions below
to review your changes.
Channel Mapping Review
Steps
1. Press PRG.
2. Press VCR+.
Remote Display
PROGRAM
GUIDE CH - TV CH
3. Press REVIEW repeatedly
to view the VCR Plus+
GUIDE CH numbers you
have mapped.
4. Press ENTER when finished.
XXX,YYY=Your entered information
GUIDE CH - TV CH
XXX YYY
When you are finished reviewing your channel mapping
changes, your remote will be ready to use for recording
programs that have VCR PlusCode numbers. See VCR
Plus Recording on the next page.
®
3130A-O 4 -- 8