Table of Contents
Advertisement
REMOTE
CONTROL
MBR3455
PROGRAMMING
YOUR
REMOTE
If you are using Zenith products, the remote is programmed for
the most commonly used codes. For other brands -- or if your
remote fails to control your Zenith products -- you will have
to program the remote.
Follow these steps for each product you are using:
1. Look up the three-digit
code for your brand (such as
Zenith) and type of equipment
(such as VCR) in the
code table provided.
2. Press and hold PRG with a small blunt object until
the indicator
lights (about three seconds).
3. Press TV, VCR, CABLE,
or AUX to select the prod-
uct you want your remote to control.
(Use CABLE
or AUX, to program
your remote for a second TV or
VCR. Use AUX, to program your remote for a video
disc player or audio equipment.)
,
o
Key in the three-digiit
code for your equipment,
then press ENTER.
'The indicator
light should
flash, then turn off to iadicate
that the code was ac-
cepted. If the indicator
stays on, repeat steps 3 and
4 or try using a different
code.
Write the code that operates
your equipment,
on the la-
bel inside
the battery
compartment
for future
refer-
ence.
To erase all code programming and return to the factory preset
codes, key in code 911 when programming the remote.
NOTES:
• If no key on your remote is pressed within 60 seconds, the
programming process stops, and you will have to start again.
• You may cancel programming at any time by pressing PRG.
SPECIAL
FEATURES
AUX+I, AUX+2 and AUX+3 Capability
Your remote can control up to seven electronic components. If
you have programmed the remote for four components using the
TV, VCR, CABLE and AUX keys, you may also program it
for up to threeadditionalcomponents (AUX+I, AUX+2, AUX+3)
by HOLDING the AUX key andpressing the 1, 2 or 3 key during
programming. Once programmed, HOLD down the AUX key and
press 1, 2 or 3, to access the additional AUX +1, 2 or 3 mode.
Cable/Converter
Volume (Code 399)
You may use your remote to control cable/converter volume and
muting if awtilable on your equipment. First program your remote
with the brand code for your cable device using the CABLE or AUX
key. Then repeat the programming steps, again using the CABLE
or AUX key, but key in code 399 instead of a brand code.
To restore TV volume/mute to the CABLE or AUX mode, simply
re-enter yofir cable converter code number into that mode.
Amplifier Volume Override (Code 499)
You may use your remote to override your TV, VCR or video
disk player's volume functions with your amplifier's volume and
muting. First, program your ten:ote with the br_ald code for the
component fi3rwhich you want amplifier volume override, using
the key for that product: TV, VCR or AUX. Then, program your
remote with r.hebrand code for your amplifier. Finally, repeat the
programming steps, using the key for the component you wish to
control (TV, VCR, or AUX), but key in code ,199 instead of a
brand code.
To restore normal volume and hinting control to your TV, pro-
gram any code into the mode where the audio amplifier code is
programmed
NOTE:
• CD and tape players will automatically
select amplifier vol-
ume and mute.
2916-0
3 ----4
Advertisement
Table of Contents
