Programming The Remote - Zenith Z44SZ80 Installation And Operating Manual

Programming the Remote

Programming the Remote
The Remote Control for your HD receiver is a multi-brand or universal
programmed to operate most remote-controllable devices of other manufacturers.
Note: The Remote Control
1. Test your Remote Control.
To find out whether your
with out programming, turn on the device such as a the VCR and
press the corresponding mode button (VCR) on the remote con
trol while pointing at the device. Test the POWER and CH +/- but
tons to see if the device responds properly. If not, the remote
requires programming to operate the device.
2. Turn on the device to be programmed. Then press the corre
sponding mode button on the
3. Press the POWER button and the MUTE button simultaneously.
Now the Remote Control
responding device.
4. There are two ways to find the right code for the device.
A. If you press the CH +/- buttons repeatedly, the codes will change
one at a time. Press the POWER button after each code change.
If the right code is found, the device will turn off.
B. Enter a code number using the number buttons on the
The right code numbers for the corresponding component can be
found on the following pages.
Again, if the code is correct, the device will turn off.
5. Press the EXIT button to store the program.
6. Test the Remote Control
properly. If not, repeat from step 2.
may not be able to control all models of other brands.
Remote Control can operate the device
Remote Control.
is ready to program the code for the cor
functions to see if the device responds
Remote Control
2
4
3
Remote.
Programming the Remote
that can be
TV VCR CABLE DVD SAT
MODE LIGHT POWER
TV INPUT
TV/VIDEO INFO
EZ Video EZ Sound SLEEP
1 2 3
4 5 6
7 8 9
0
FLASHBK
FAV
MUTE
+
SAP ADJUST
VOL CH
-
PIP PIPCH- PIPCH+ SWAP
CC FREEZE PIP INPUT
RATIO
MENU EXIT
PLAY PAUSE STOP RECORD
REW FF
SKIP
Owner's Manual 39
3
4
5