Programming The Remote - Zenith R56W36 Installation And Operating Manual

Programming the Remote

The remote control for your HD receiver is a
multi-brand or universal remote control. It can
be programmed to operate most remote-con-
trollable devices of other manufacturers.
Note that the remote control may not control
all models of other brands.
Test your remote control.
1
To find out whether your remote control can
operate the component without program-
ming, turn on the component such as a VCR
and press the corresponding mode button
(VCR) on the remote control, while pointing
at the component. Test the POWER and CH
+/- buttons to see if the component
responds properly. If not, the remote
requires programming to operate the device.
Turn on the component to be programmed.
2
Then press the corresponding mode button
on the remote control.
Press the POWER button and the MUTE but-
3
ton simultaneously. Then the remote control
is ready to program the code for the corre-
sponding component.
There are two ways to find the right code for
4
the component.
A. If you press the CH +/- buttons repeat-
edly, the codes will change one at-a-time.
Press the POWER button after each code
change. If the right code is found, the
device will turn off.
B. Enter a code number using the number
buttons on the remote. The right code num-
bers for the corresponding component can
be found on the following pages.
Again, if the code is correct, the device will
turn off.
Press the EXIT button to store the code.
5
Test the remote control functions to see if
6
the component responds properly. If not,
repeat from step 2.
P A G E 4 6
vcr cable dvd sat
tv
mode
light
2
tv/video comp
arc cc
1 2
4
4 5
7 8
0
flashbk
fcr
vol
pip pipch- pipch+
pip input video
position
up
enter
left
menu
down
play stop
pause
rew
ff
power
3/4
sleep
auto conv
3
6
9
mute
3
4
ch
swap
audio
right
exit
5
record
skip
206-03865