Air Conditioner Use - Whirlpool ACE184PT1 Use & Care Manual

Electrical Shock Hazard
Connect green ground wire to ground screw,
Failure to do so can result in death or electrical shock.
3. Connect the green ground wire to the ground screw,
Position the ground wire pointing straight up, Put the excess
ground wire between the coil and the air conditioner cabinet.
5. Using 2 - #10 x %" painted round-head screws attach the
bottom front of the panel.
NOTE: For through-the-wall installations, if needed, install the
molding around the room side of cabinet.
4.
.......B
A. Green ground wire
B. Ground screw
Push front panel straight on and then lower it slightly to lock it
into place.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
6. Plug into a grounded 3 prong outlet.
7. Press RESET on the power supply cord. See "Electrical
Requirements."
AIR CONDITIONER USE
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
• If you turn off the air conditioner, wait at least 3 minutes
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
Do not try to operate your air conditioner in the cooling mode
when outside temperature is below 65°F (18°C). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
11