Foxconn K8S760MG series User Manual page 49

First/Second/Third Boot Device (Default: Floppy/Hard Disk/LS120)
This option allows you to set the boot device sequence. The available setting
values are: Floppy, LS120, Hard Disk, CDROM, ZIP100, USB-FDD, USB-ZIP,
USB-CDROM, LAN, and Disabled.
Boot Other Device (Default: Enabled)
With this function set to Enabled, the system will boot from some other
devices if the first/second/third starting devices failed.
Swap Floppy Drive (Default: Disabled)
If it is set to Enabled, the label of FDD A and B can be exchanged. The
available setting values are: Disabled and Enabled.
Boot Up Floppy Seek (Default: Enabled)
If this option is enabled, BIOS will tests floppy drives to determine whether
they have 40 or 80 tracks. The setting values are: Disabled and Enabled.
Boot Up NumLock Status (Default: On)
This option is used to set up the NumLock status after the startup. When it is
set to On, the NumLock will be activated during system startup. When it is set
to Off, users can use the number keys instead of the arrow keys to move the
cursor. The available setting values are: On and Off.
Gate A20 Option (Default: Fast)
This option is used to set up the A20 signal control necessary for access to
the 1 MB memory. The available setting values are: Normal and Fast.
Typematic Rate Setting (Default: Disabled)
If this option is enabled, you can use the following two items to set the
typematic rate and the typematic delay settings for your keyboard. The avail-
able setting values are: Disabled and Enabled.
Typematic Rate (Chars/Sec) (Default: 6)
Use this option to define how many characters per second a held-down key
generated.
Typematic Delay (Msec) (Default: 250)
Use this option to define how many milliseconds must elapse before a held-
down key begins generating repeat characters.
42
42
Chapter 3 BIOS Description
2004-9-14, 8:42