Foxconn K8S760MG series User Manual page 68

Chapter 3 BIOS Description
Load Fail-Safe Defaults
Select this option and press <Enter>, it will pop up a dialogue box to allow you
to load default set by BIOS. Press <Y> and then <Enter> to load default. Press
<N> and <Enter>, it will not load. The defaults set by BIOS have set the basic
functions of system to ensure the stability of system. But if your computer fails to
properly run, you may load the default to make the system recover normal, then
carry out failure testing in next step. If you only want to load the default as an
option, you can select this option and press the key <F6>.
Load Optimized Defaults
Select this option and press <Enter>, it will pop up a dialogue box to let you load
the optimized defaults set by BIOS. Press <Y> and <Enter> to load the optimized
defaults. Press <N> and <Enter>, it will not load. The defaults set by BIOS have
set the optimized performance parameters of system to improve the perfor-
mances of system components. But if the optimized performance parameters
to be set cannot be supported by your hardware devices, it will cause system to
make mistakes or not stable. If you only want to load the optimized defaults as
an option, you can select this option and press the key <F7>.
Set Supervisor/User Password
The preferential grade of supervisor password is higher than user password.
You can use supervisor password to start into system or enter into CMOS set-
ting program to amend the settings. You can also use user password to start
into system, or enter into CMOS setting menu to check, but if you have set
supervisor password, you cannot amend the settings.
When you select Set Supervisor / User Password, it will appear the following
message in the center of screen, which will help you to set password.
Enter Password:
Enter your password, not exceeding 8 characters, then press <Enter>, the pass-
word you have entered now will replace the previous password. When the sys-
tem requires you to determine this password, you can enter this password and
press <Enter>.
If you do not need this setting, you can press <Enter> when the screen prompts
you to enter password, and the screen will appear the following message to
show this function invalid. In this case, you can freely enter into system and
CMOS setting program.
PASSWORD DISABLED!!!
Press any key to continue...
61
61 2004-9-14, 8:42