Foxconn 600A01 series User Manual page 59

Onboard FDC Controller (Default: Enabled)
This option is used to set whether the Onboard FDC Controller is enabled.
The available setting values are: Disabled and Enabled.
Onboard Serial Port1/2 (Default: 3F8/IRQ4 / 2F8/IRQ3)
This option is used to assign the I/O address and interrupt request (IRQ) for
the onboard serial port 1/2.
Note: Do not try to set the same values for serial ports 1 and 2.
Onboard Parallel Port (Default: 378/IRQ7)
This option allows you to determine onboard parallel port controller I/O ad-
dress and interrupt request (IRQ). The setting values are: Disabled, 378/IRQ7,
278/IRQ5 and 3BC/IRQ7.
Parallel Port Mode (Default: SPP)
Select an address and corresponding interrupt for the onboard parallel port.
The setting values are: SPP, EPP, ECP, ECP+EPP.
ECP Mode Use DMA (Default: 3)
When the Parallel Port Mode is set to ECP or ECP+ EPP, this option is used to
select the channel for the ECP mode. The setting values are: 1 and 3.
Onboard Fast IR (Default: Disabled)
This option is used to enable or disable onboard fast IR. The setting values
are: Disabled and Enabled.
Fast IR IRQ (Default: 11)
This option is used to set fast IR IRQ. The setting values are: 11, 5, 3, 4.
Fast IR DMA (Default: 6)
This option is used to set fast IR DMA. The setting values are: 6, 5.
600A01-FOXCONN-V1.0-BIOS-en.p65
Chapter 3
SuperIO Device Menu
600A01 Series User Manual
51
BIOS Description
51
2004-4-12, 13:31