Foxconn 955X7AA series User Manual page 58

Chapter 3 BIOS Description
SuperIO Device Menu
Onboard FDC Controller (Default: Enabled)
This option is used to set whether the onboard FDC controller is enabled.
The available setting values are: Disabled and Enabled.
Onboard Serial Port 1/2 (Default: 3F8/IRQ4 / 2F8/IRQ3)
This option is used to assign the I/O address and interrupt request (IRQ) for
the onboard serial port 1/2.
UART Mode Select (Default: ASKIR)
Use this option to select the UART mode. Setting values include Normal,
IrDA, ASKIR. The setting value is determined by the infrared module installed
on the board.
RxD, TxD Active (Default: Hi, Lo)
This item allows you to set the RxD, TxD Active.
IR Transmission Delay (Default: Enabled)
This item allows you to set the IR Transmission Delay.
UR2 Duplex Mode (Default: Half)
This option is available when UART Mode Select is set to either ASKIR or
IrDA. This item enables you to determine the infrared function of the onboard
infrared chip.
Use IR Pins (Default: IR-Rx2Tx2)
This item allows you to set the Use IR Pins.
Onboard Parallel Port (Default: 378/IRQ7)
This item allows you to determine onboard parallel port controller I/O address
and interrupt request (IRQ). Setting values include Disabled, 378/IRQ7, 278/
IRQ5, and 3BC/IRQ7.
51
955X7AA Series User Manual