Table of Contents
Advertisement
5. Inspect the gasket seal for proper closure. A complete seal can be visually confirmed
by looking for the black line made by the gasket around the complete circumference of
the housing.
Note!
F
8: R
IGURE
EPLACING THE
If the gasket is in good contact, a thin black line, about 0.5-
1mm in width should be visible where the gasket is in
contact with the lid. Follow this line all the way round the
edge of the seal as a final check that the seal is good. The
housing is now ready for the dive.
F
9: I
IGURE
NSPECTION OF
L
ID
O-
RING
13
Advertisement
Table of Contents
