Table of Contents
Advertisement
compartment, aligning the markings on the battery
compartment door with those on the left side of the battery
compartment, and proceed by carefully pushing the door
against the batteries. Once the door is properly aligned,
gently slide the knob to the right side in order to secure
the closure. Make sure that once you stop applying
pressure on the battery compartment door, it remains
closed.
F. Turn the flash on by setting the power switch to the ON (
position. If batteries were installed properly, the Ready
Light should turn on after a few seconds.
G. When the Ready Light is on, the flash can be tested by
turning the power switch to TEST (
the power switch to OFF (O) after the test.
Do not allow any drops of water to enter the battery compartment
when installing or removing batteries.
5. Setting the Proper Pre-Flash Program for Your Camera
Please note that watching the Remora Flash fire does not
mean it triggers on the right timing. If it is not synchronized
with your camera, this will usually result in underexposed
images.
What are Pre-Flashes?
Pre-flashes are one or more flashes given out to assist in the
focusing and exposure setting of the camera before the actual
picture-taking primary flash is fired. It is important to set the
6
). Make sure to set
I
)
Advertisement
Table of Contents
