Water Filter Certifications - Whirlpool ED2SHAXML12 Use & Care Manual

The water dispenser will not operate properly
• Freezer door closed completely? Close the door firmly. If it
does not close completely, see "The doors will not close
completely."
• Refrigerator connected to a water supply and the supply
shutoff valve turned on? Connect refrigerator to water
supply and turn water shutoff valve fully open.
• Is the water pressure at least 30 psi? The water pressure to
the home determines the flow from the dispenser. See "Water
Supply Requirements."
Kink in the home water source line? Straighten the water
source line.
New installation? Flush and fill the water system.
Water filter installed on the refrigerator? The filter may be
clogged or incorrectly installed.
Is a reverse osmosis water filtration system connected to
your cold water supply? See "Water Supply Requirements"
in either the Installation Instructions or the Use & Care Guide.
Water is leaking from the dispenser
NOTE: One or two drops of water after dispensing is normal.
WATER FILTER CERTIFICATIONS
State of Caldo*'ma
Deparmlent of Health Services
Water Treatment Device
Certificate Number
03 - 1550
Date I_u_'d Jgmuary 2I.?0(H
TrademarkJ_',fodel Desi_llation ReDlacenlent Elements Rated t"a_
WhMpool WF-NL241 NL240 !40 gal
4OO gal
he water treatment (levite(s) hsted on this certifleat_ ha_e met _llc testing reqairement_ pursuant to Section
116830 ol the Health _l_d Sal'_'ty (2ode fur the _ollo_ia_ health related contaminants;
_lier(_hi_lo_icat (:(mr amlnaat_ and Turhidit_ I no r _a_i_Radi olo_ieai Contaminant_
Ntm_ N_w
Organic Contaminants
I e_t
Cut Hazard
Use a sturdy glass when dispensing ice or water.
Failure to do so can result in cuts.
• Glass not being held under the dispenser long enough?
Hold the glass under the dispenser 2 to 3 seconds after
releasing the dispenser lever.
• New installation? Flush the water system. See "Ice and
Water Dispensers."
• Recently changed water filter? Flush the water system. See
"Ice & Water Dispensers."
The dispenser water is not cool enough
NOTE: Water from the dispenser is chilled to only 50°F (10°C).
• New installation? Allow 24 hours after installation for the
water supply to cool completely.
• Recently dispensed large amount of water? Allow 24 hours
for water supply to cool completely.
• Water not been recently dispensed? The first glass of water
may not be cool. Discard the first glass of water.
• Refrigerator connected to a cold water pipe? Make sure
the refrigerator is connected to a cold water pipe. See "Water
Supply Requirements."
Rated Service Flow: 05gpm
no not use with water that is microbiologically unsafe
or ol unknown
q_alay, without adequate disinfection
heR)re or after the system.
Slale of Califi_rnia
Department of Health Services
Water Treatment Device
CertificateNumber
03 - 1549
Date Issued January 21. 2003
rrademark/Model Designation
Whirlpool WF-NL240V
WhMpool W_[A00V
Manufaetarer:
The water treatment
None
Replacement Elements Rated Ca_
NL2g0V 240 gal
400 gal
Do not use with water that is micrnbiologically ansafe or of unknown qaality, without adequate disinfection
hefore or after the system.
11