Table of Contents
Advertisement
L-
]i
ii !' _"_ i _i _
_ _L_i
_ _#_
•
_ _ i _II_ !
,_ <
17. Attach the Le_ F_ .Jp Arm :75) and the Fl!ghl
Pull-up Arm (77) to me Assis_ Upright (74)
with two 5/16" x 2 3/4" Bolts (!1) and two
5/16" ;',_y!on!.cc=',nu_s (3).
Attach the Left Dip Arm (78) and the Right Dip
Arm (79) to the Assist Upright (74) with two
_16"x
2 3/4" Bolts (11) and two 5116" Nylon
Locknuts (3).
Wet the end of the Left Pull-up Arm (75) with
soapy water. Slide a Long Handgrip (80) onto
the Left Pull-up Arm.
Slide a Long Handgdp (80) onto the Right
Pull-up Arm (77), onto the Left Dip Arm (78),
and onto the Right Dip Arm (79) in the same
manner.
Press two 1 1/4" Round Inner Caps (109) into
the Left Pull-up Arm (75) and into the Right
Pull-up Arm (?'7).
Press a 1 1/4" Round Inner Cap (109) into the
Left Dip Arm (78), and into the Right Dip Arm
(79).
18. Locate and open the parts bags labeled
"CABLE ASSEMBLY"
and "PULLEYS."
During steps 19 through 39, refer to the
CABLE DIAGRAMS on pages 26-27 of this
manual to verify proper cable routing. Before
beginning this section, fully unwind the four
Cables. Identify the four Cables by comparing
approximate
length of each Cable is listed (in
inches) after the key number in the drawing.
IMPORTANT:
While assembling
the cables,
....
•. ",-b_r,
",.hebolts _n_ nuts
a_a_hl_It.i
_;;_'.;_uiieys, The pulleys must be
able
iO
i.ur_'l
_i'a_iy.
19, Locate the High Cable (58). Wrap the High
Cable around a 3 1/2" Pulley (15). Attach the
Pulley to the Top Frame (55) with a 3/8" x
3 3/4" Bolt (88) and a 31'8"Nylon Locknut (21).
Be sure that the end of the Cable with the
ball Is on the Indicated side of the Pulley
and that the Cable is between the Pulley
and the hook.
18
75
74
80
\
\
88
11
Hide quick links:
Advertisement
Table of Contents
