Weider PRO 9645 User Manual page 17

36. Slide a 5/16" Flat Washer (8) onto a 5116" x
2 3/4" Bolt (11). Insert the Bolt through the indi-
cated hole in the Pivot Arm (101). The Bolt
must be inserted from the side shown.
Fully tighten a 5/16" Nylon Jam Nut (93) onto
the Boil
Wrap the Military Press Cable (72) around a
3 1/2" Pulley (15). Attach the Pulley and a
Cable Trap (66) to the Pivot Arm (101) with
the 3/8" x 3 3/4" Bolt (88), a 3/8" Flat Washer
(9), and a 3/8" Nylon Locknut (21). Be sure
that the Pulley is on the side shown and
that the Cable Trap is positioned to hold
the Cable in place.
36
37. See inset drawing A. Attach a 3 1/2" Pulley
(15) and a Cable Trap (66) to the upper hole
in a Long "U"-Bracket (57) with a 318" x 2"
Bolt (12) and a 3/8" Nylon Locknut (21). Be
sure that the Cable Trap is inside the Long
"U"-Bracket. (Note: This may come pre-
assembled.)
Route the Military Press Cable (72) through
the Long "U"-Bracket (57) and the 3 1/2"
Pulley (15). Be sure that the Cable Is In the
groove of the Pulley and that the Cable
and Pulley move smoothly.
See inset drawing B, Slide the end of the
Military Press Cable (72) onto the end of the
5/16" x 2 3/4 Bolt (11). Thread another 5/16"
Nylon Jam Nut (93) onto the Bolt. Do not
fully tighten the second Jam Nut. There
must be room between the two Jam Nuts
for the end of the Cable to pivot.
37
\
72
93\
17