Weber Summit E-420 Owner's Manual page 23

Lp gas grill
Hide thumbs Also See for Summit E-420:
Table of Contents

Advertisement

MAIN BURNER MANUAL LIGHTING
DANGER
Failure to open the lid while igniting the barbecue's burners,
or not waiting 5 minutes to allow the gas to clear if the
barbecue does not light, may result in an explosive flame-up
which can cause serious bodily injury or death.
1)
Open the lid.
2)
Make sure all burner control knobs are turnedoff. (Push each knob in and turn
clockwise to ensure they are in the "OFF" position.)
A WARNING:
The burner
control
knobs
must
be in the "OFF"
position
before
turning
on the liquid
propane
cylinder
valve.
If they
are not in the "OFF"
position,
when
you
turn
on the
LP cylinder
valve,
the "excess
gas flow
control"
feature
will
activate,
limiting
the flow
of gas from
the LP cylinder.
If this
should
occur,
turn
off the LP tank
valve
and burner
control
knobs.
Then
start
over.
A DANGER
When the "excess
gas flow control" feature
is activated,
a small amount of gas is still flowing
to the burners.
After
turning
off the cylinder
and burner control
knobs, wait at
least 5 minutes for the gas to clear before attempting
to light
the barbecue.
Failure to do so may result in an explosive
flame-up,
which can cause serious
bodily injury or death.
3)
Turn the cylinder on by turning the cylinder valve counterclockwise.
4)
Put match in the match holder and strike match.
A WARNING:
Do not lean
over
open
barbecue.
5)
Insert match holderand lit match down through cooking grates and Flavorizer_
bars to ignite the selected burner.
6)
Push the control knob in and lurn to "START/HI".
A WARNING:
If the burner
does
not light,
turn
the burner
control
knob
to "OFF"
and wait
5 minutes
to let the gas clear
before you try again.
MAIN BURNER MANUAL LIGHTING
*The grill illustrated
may have
slight
differences
than the
model
purchased.
TO EXTINGUISH
Push in and turn each burner control knob clockwise
to "OFF" position.Turn
gas supply
OH al the SOUrCe.
LIGHTING THE SIDE BURNER
.4',DANGER
Failure to open the lid while igniting the side burner, or not
waiting
5 minutes
to allow the gas to clear if the side burner
does not light, may result in an explosive
flame-up
which can
cause serious
bodily injury or death.
A WARNING: Check hose before each use of barbecue for nicks,
cracking,
abrasions
or cuts. If the hose is found to be damaged
in any way, do not use the barbecue. Replace using only WebeP
authorized
replacement
hose. Contact
the Customer
Service
Representative
in your area using the contact
information on
our web site. Log onto www.weber.com ®.
1)
Open the side burner lid.
2)
Check that the side burner valve is turned off (Push control knob in and turn
clockwise to ensure that it is in the "OFF' position), turn all burners not being used
to the "OFF" position (push in and turn clockwise).
3)
Turn the gas supply valve on.
4)
Push down and turn the side burner control valve to "HI".
5)
Press the igniter button several times so it clicks each time.
A CAUTION:
Side burner
flame
may
be difficult
to see on a
bright
sunny
day.
A WARNING:
If the side burner
does
not light
in five
(5)
seconds:
a)
Turn
off the side
burner
control
valve,
main
burners
and gas supply
at source.
b)
Wait 5 minutes
to let the gas clear before
you try
again,
or try lighting
with a match
(see "Manually
Lighting the Side Burner").
SlDE BURNERLIGHTING

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Summit e-450Summit s-420Summit s-45089559

Table of Contents