How To Use The Turbo Nozzle; Max Nozzle; Cleaning Detergent Nozzle; Cleaning And Applying Detergent - Troy-Bilt 020245-1 Owner's Manual

Section 4: Operation
For maximum rinsing (higher pressure and iower
flow), for stubborn or hard to reach surface such
as second story surfaces, paint removal oii stains,
rust removai or other stubborn substances (tar,
gum, grease, wax, etc.), select red Hax
ProjectPro TMnozzle (Figure 16).
To apply detergent, applies project specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces, select black ProjectPro TM
cleaning detergent nozzle (Figure 17).
Now to Use the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a
rapid circular pattern.Always start the turbo nozzle at a
distance, gradually getting closer to the surface until you
get the cleaning force you want.
CAUTION
Always make sure the surface you will clean win not be
damagedby the high pressure spray by testing in a hidden area.
I. Pull back collar on quick-connect and pull current
ProjectPro TM nozzle off. Store ProjectPro TM nozzles in
holder provided on the accessory tray.
2. Pull back on collar, insert turbo nozzle and release
collar (Figure 18).Tug on turbo nozzle to make sure it
is securely in place.
3. For most effective cleaning, keep turbo nozzle from 8 to
24 inches away from cleaning surface. If you get turbo
nozzle too close, you may damage cleaning surface.
NOTE: Detergent cannot be applied with the turbo
nozzle.
aeaning and Applying Detergent
iMPORTANT: Use detergents designed specifically
for pressure washers. Household detergents could
4. Pull back on collar, insert selected ProjectPro TMnozzle
and release collar.Tug on ProjectPro TMnozzle to make
sure it is securely in place.
5. For most effective cleaning, keep ProjectPro TM nozzle
from 8 to 24 inches away from cleaning surface, ff you
get the nozzle too close, you may damage the cleaning
surface.
6. DO NOT get closer than 6 inches when cleaning tires.
• Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
Damage to equipment resulting from failure to follow this
instruction will void warranty.
To apply detergent follow these steps:
I. Review ProjectPro TMnozzle use.
2. Prepare detergent solution as required by
manufacturer.