Troy-Bilt 1919 Owner's Manual page 6

ASSEMBLY
Your generator reqores some assembHy and is ready for
use after it has been properHy serviced with the
recommended oiH and fuel
Jf you have any proMems with the assernbmy of your
generator, Dmease carom the generator hempmine at
l=888=61 l =6708°
Remove Generator From Carton
H. Set cartonon a rigid fiat surface with"ThisSideUp"
arrows pointing upward.
2. Carefully open top flaps of shipping carton.
3. Cut down corners at one end of carton from top to
bottom and Haythat side of carton down fiat.
4. Remove aHH packing material carton fiHHers, e tc.
5. Remove generator from shipping carton.
Install Wheel
Kit
The wheeH kitisdesignedto greatly improve the portability
of your generator.
NOT_=: Whee[ kit is not intended for over-the-road use.
You wiHHneed a socket wrench with H/2" or H3mm sockets
and a needHe-nose pHiers to install[ this kit.
[. PHacebottom of generator cradHe on a fiat, even
surface.TemporariHy pHace unit on bHocks to ease
assembHy.
2. SHideaxHethrough both axHe mounting brackets on
cradHe frame, as shown in Figure H.
3. SHidea whee[ over axHe.
NOT_=: Be sure to install[ both wheeHs with the air
pressure vaHveon the outboard side.
4. PHacee-ring onto groove in axHe.You may add the fiat
washer if desired.
Cap Screw
\\
\
Hex Nut
/
HandHeAssembHy
Support Leg
Hex Nut .......
\
Cap Screw
AxHe
,/
Wheel
Hat _A/asher
/
/
E=Ring
0