Troy-Bilt 1919 Owner's Manual page 12

SPECmFmCATmONS
Maximum Surge Watts .................. 8,550 watts
Continuous VVattage Capacity ............ 5,550 watts
Power Factor ................................ H.0
Rated Maximum Continuous AC Load Current:
At H20VoHts ......................... 46.2 Amps
At 240VoHts ......................... 23.H Amps
Phase .................................. H-phase
Rated Frequency ......................... 60 Hertz
FueHTank Capacity .................... 5 U.S. gaHHons
Shipping'C_/oght .......................... H 69 Hbs.
GENERAL MAmNTENANCE
RECOMMENDATmON$
The Owner/Operator is responsibHe for making sure that
aHH periodic maintenance tasks are completed on a timeHy
basis; that aHH discrepancies are corrected; and that the unit
is kept dean and properHy stored.
NEVER
operate a
damaged
or defective generator.
ShouHd you have questions about repHadng components on
yourTroy°BiHt_) generator_ pHease caHH m-o88-6m m-6T08 for
assistance.
_ine Maintenance
See engine owner's manuaH for instructions.
CAUTION
m
* Used motor oil has been shown to cause skin cancer in
certain laboratory animals.
. Thoroughly wash
exposed areas
with soap and water:
KEEP OUT OF REACH OF CHILDREN. DON'T
POLLUTE. CONSERVE RESOURCES. RETURN
USED OILTO COLLECTION CENTERS.
Generator Maintenance
Generator maintenance consists of keeping the unit dean
and dry. Operate and store the unit in a dean dry
environment where it wiHHnot be exposed to excessive
dust, dirt, moisture or any corrosive vapors. CooHing air
shots in the generator must not become cHoKed with snow,
Heaves or any other foreign materiaH.
NOTE: DO NOT use a garden hose to dean generator.
VVater can enter engine fuel system and cause probHems. In
addition, if water enters generator through cooHing air shots,
some of the water wiHH be retained in voids and cracks of
the rotor and stator winding insuHation._A/ater and dirt
buiHdup on the generator internaH windings wiHH eventuaHHy
decrease the insuHation resistance of these windings.
Generator Cleaning
* Use a damp cHoth to wipe exterior surfaces dean.
®
®
®
DO NOT expose generator to excessive moisture, dust, dirt,
or corrosive vapors_
DO NOT insert any objects through cooJing sJots.
Use a soft bristle brush to Hoosen caked on dirt or oiH.
Use a vacuum cHeaner to pick up Hoose dirt and debris.
Use How pressure air (not to exceed 25 psi) to bHow away
dirt. Inspect coding air shots and opening on generator.
These openings must be kept dean and unobstructed.
D ata Ta_
Data tag information is very important if you need heHp from
our Customer Service Department or an authorized service
dealer.
° The data tag (Figure 9) is located either on the heat shieHd
or engine support on the muffler side of the generator.
For future reference, pHease copy the model revision, and
seriaH number of the generator in the space below.
MODEL l
REV NO [
SERIAL [
AC VOLTS [
AC AMPS [
AC WATTS [
DC VOLTS [
DCAMPS [
I f NCu°PbYerM°Hde_e
j,
Co W Revision
Here
Copy SeriaH
Number Here
J
]
i
i