SECTION 2: ASSEMBLING YOUR SNOW THROWER
NOTE: All references
to left or right side of the snow
thrower is from the operating position only.
Raising UpperHandle
•
Loosen the hand knob on each side of the handle.
Remove packing material, if any.
Figure 1
•
Raise the upper handle in the direction shown in
Figure 1 until it clicks into the operating position.
Make sure not to pinch or crimp the cable.
•
Tighten the hand knobs.
Assembling t he ChuteAssembly
For shipping reasons, the snow thrower has been
packaged with the upper chute pivoted all the way
down. To pivot it upward, proceed as follows:
•
Turn the chute until the chute opening is facing
straight ahead.
•
Remove the wing knob, flat washer and carriage
bolt from the lower chute. See Figure 2.
•
Pivot the upper chute upward over the lip on the
lower chute so that there is NO gap between the
upper chute and the lower chute. See Figure 2.
•
Re-secure with the hardware just remove
IMPORTANT: Do not use the chute handle to lift the
snow th rowe r.
Carriage Bolt and Flat Washer
Wing Knob
Figure 2