Table of Contents
Advertisement
Operator's Manual
Single Stage
Snow Thrower
Models E285 (521) & E295 (721)
IMPORTANT:
Read safety rules and instructions
carefully
before operating
equipment.
Warning:
This unit is equipped with an internal combustion engine and should not be used on or near any unimproved
forest-
covered, brush-covered
or grass-covered
land unless the engine's exhaust system is equipped with a spark arrester meeting
applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.
In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have
similar laws. Federal laws apply on federal lands. A spark attester for the muffler is available through your nearest engine authorized
service dealer or contact the service department,
P.O. 8ox 361131 Cleveland, Ohio 44136-0019.
TROY-BILT
LLC. P.O. BOX 361131 CLEVELAND,
OHIO 44136-0019
PRINTED IN U.S.A.
FORM NO. 769-00309
(8/2002)
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Troy-Bilt E295
Summary of Contents for Troy-Bilt E295
- Page 1 Federal laws apply on federal lands. A spark attester for the muffler is available through your nearest engine authorized service dealer or contact the service department, P.O. 8ox 361131 Cleveland, Ohio 44136-0019. TROY-BILT LLC. P.O. BOX 361131 CLEVELAND, OHIO 44136-0019 PRINTED IN U.S.A.
- Page 2 TABLEOF CONTENTS Content Page Important Safe Operation Practices .................. Assembling Your Snow Thrower ..................Know Your Snow Thrower ....................Operating Your Snow Thrower ..................Making Adjustments ......................Maintaining Your Snow Thrower ..................Off-Season Storage ......................Troubleshooting ........................ Parts List .......................... FINDINGMODELNUMBER This Operator's Manual is an important part of your new snow thrower.
-
Page 3: Important Safe Operation Practices
SECTION 1: IMPORTANT SAFEOPERATION P RACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. - Page 4 4. Never operate with a missing ordamaged discharge Maintenance & Storage chute. Keep allsafety d evices inplace a nd working. Never tamper with safety devices. Check their proper 5. Never runanengine i ndoors orinapoorly v entilated area. E ngine e xhaust contains carbon m onoxide, an operation regularly.
-
Page 5: Assembling Your Snow Thrower
SECTION 2: ASSEMBLING YOUR SNOW THROWER Unpacking FromCarton • Remove the hairpin clip from the end of the lower chute crank. • Cut along corners of the carton and lay it down flat. • Insert the upper chute crank into the lower chute Remove packing material. -
Page 6: Know Your Snow Thrower
handle. H old the"Z"fittingwiththepliers, n otthe cable, t oavoid damaging t hecable. Lower Chute NOTE: The upper hole in the control handle provides Bolt for adjustment in belt tension. Refer to page 9 of this Flat manual for instructions. Washer f Flat Assembling Discharge Chute •... -
Page 7: Operating Your Snow Thrower
DischargeChute Ignition Key The angle of the discharge chute controls the distance Used to start engine. Put key in "ON" position to start that the snow is thrown. Tilt the discharge chute up for for both electric and recoil start engines. Follow starting greater distance;... - Page 8 • If you have a grounded three-prong receptacle, or four times. Pulling the starter rope will produce a proceed as follows. loud clattering sound, which is not harmful to the • Rotate choke lever to FULL position. engine or starter. •...
-
Page 9: Making Adjustments
SECTION 5: MAKING ADJUSTMENTS BeltTension WARNING: NEVER attempt to make any Periodic adjustment of the belt tension may be required adjustments while the engine is running, due to normal stretch and wear on the belt. Adjust the except where specified in the operator's belt tension if the augers seem to hesitate while turning manual. -
Page 10: Maintaining Your Snow Thrower
SECTION 6: MAINTAINING YOUR SNOW THROWER • Push down on the idler pulley and slip the belt off the auger pulley. See Figure 13. WARNING: • Reassemble new belt. Reinstall the belt cover. Before servicing, repairing, or inspecting, disengage all clutch levers and stop engine. -
Page 11: Troubleshooting
SECTION 8: TROUBLESHOOTING GUIDE Problem Cause Remedy Engine fails to start Fuel tank empty, or stale fuel Fill tank with clean fresh gasoline. Blocked fuel line Clean fuel line Key not in ON position Insert key and turn to ON position Spark plug wire disconnected Connect wire to spark plug. -
Page 12: Parts List
SECTION 9: PARTS LISTFORMODELS 521AND721 r_15 17_\... - Page 13 Models521& 721 Ref. No. Ref. No. Part No. Part No. Part Description Part Description 884-0174 710-0451 Upper Chute Crank Assemby Carriage Bolt 684-0177 710-0642 TT Screw 1/4-20 x 0.75" Lower Chute Crank Assembly TT Screw 3/8-16 x 0.5" 684-0178 710-0773 Bracket Assembly: Mitten Grip 731-04075 710-0896...
- Page 14 Models521and721 Engine is for reference only and may not resemble the engine on your snow _rower. Ref. No. Part No. Description Ref. No. Part No. Description Extension Cord 736-0242 Beleville Washer 629-0071 710-0157 Hex Bolt 5/16-24 x 0.75" 736-0329 Lock Washer 710-O409 741-0475 Hex Bolt 5/16-24 x 1.75"...
- Page 15 Models521and721 Ref. No Part No. Description 710-0487 Carriage Screw 5/16-18 x 2.0" ,710-1270 Machine Screw 712-0324 Hex Lock Nut 1/4-20 720-0284 Hand Knob w/Wing 720-0295 Foam Grip 725-0157 Cable Tie 736-0451 Saddle Washer 746-0883 Control Housing 747-0956 Auger Bail 749-0711A Upper Handle: Gull Wing NOTE: Per painted parts, please refer to the list of color codes below.
- Page 16 MANUFACTURER'S LIMITED WARRANTY FOR: The limited warranty set fodh below is given by Troy-Bilt LLC Troy-Bilt LLC does net extend any warranty for with respect to new merchandise purchased and used in the products sold or exported outside of the United States, United States, its possessions and territories.
Need help?
Do you have a question about the E295 and is the answer not in the manual?
Questions and answers