READ SAFETY RULES AND INSTRUCTIONS CAREFULLY BEFORE OPERATION
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, brush-
covered or grass-covered land unless the engine's exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any).
If a spark arrester is used, it should be maintained in effective working order by the operator. In the State of California the above is required by law
(Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. A spark arrester
for the muffler is available through your nearest engine authorized service dealer or contact the service department, P.O. Box 361131 Cleveland,
Page 1
(Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized service dealer or contact the service department, P.O. Box 361131 Cleveland, Ohio 44136-0019. FORM NO. 769-00309C PRINTED IN U.S.A TROY-BILT LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019 4/2005...
Troubleshooting... p. 13 Parts List ... p. 14 Accessories & Kits ... p. 18 Notes... p. 19 Warranty ... Back Cover www.troybilt.com Customer Support TROY-BILT LLC P. O. BOX 3 6 1 1 3 1 CLEVELAND, OH 44136 330-558-7220 866-840-6483...
DANGER: This machine was built to be operated according to the rules for safe operation in this manual. As with any type of power equipment, carelessness or error on the part of the operator can Safe result in serious injury. This machine is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury or death.
Page 5
Operation 1. Do not put hands or feet near rotating parts, in the auger/impeller housing or chute assembly. Contact with the rotating parts can amputate hands and feet. 2. The auger/impeller control lever is a safety device. Never bypass its operation. Doing so makes the machine unsafe and may cause personal injury.
Snow Thrower Setup NOTE: This Operator’s Manual covers several models. Snow thrower features vary by model. Not all features discussed in this manual are applicable to all snow thrower models. NOTE: All references to left or right side of the snow thrower is from the operating position only.
Auger Control Handle Primer Gasoline Cap Chute Assembly Shave Plate Auger Choke Lever CHOKE Activating choke control closes the choke plate on carburetor and aids in starting engine. Refer to the engine manual packed with unit for more detailed instructions. Primer Depressing primer forces fuel directly into engine’s carburetor to aid in cold-weather...
Operation WARNING WARNING: Read, understand, and follow all instructions and warnings on the machine and in this manual before operating. Use extreme care when handling gasoline. Gasoline is IMPORTANT: For complete and detailed engine extremely flammable starting, stopping and storing instructions, it is recom- and the vapors are mended that you read the engine manual also included with this unit.
10.When engine starts, release starter button, and move choke gradually to 1/2 Choke until the engine runs smoothly. Next move Choke to OFF. If engine falters, move choke immediately to FULL and then gradually to 1/2 then to OFF. 11. Disconnect the power cord. Always unplug from the outlet first, and then from the snow thrower.
Tighten securely once adjusted. NOTE: Call 1-866-840-6483 for information regarding price and availability of Shave Plate Kit 753-0451 or contact the authorized Troy-bilt Service Dealer in your area. Control Cable As a result of both the control cable and the drive belt stretching due to wear, periodic adjustments may be necessary.
NOTE: Call 1-866-840-6483 for information regarding the price and availability of Auger Kit 753-04472 or contact an authorized Troy-bilt Service Dealer in your area. To change the rubber paddles, proceed as follows: 1. Remove the existing rubber paddles by unthreading the self-tapping screws which secure them to the auger.
If the snow thrower will not be used for 30 days or longer, or if it is the end of the snow season when the last possibility of snow is gone, the equipment needs to be stored properly. Follow storage instructions below to ensure top performance from the snow thrower for many more years.
Problem Engine fails to start 1. Fuel tank empty, or stale fuel 2. Blocked fuel line 3. Key not in ON position 4. Spark plug wire disconnected 5. Faulty spark plug 6. Engine not primed 7. Engine flooded from excessive priming Engine runs erratic 1.
Page 14
You can determine which drive pulley system your unit has by measuring this hole. Units with a 3/8” hole use these part numbers. You can determine which drive pulley system your unit has by measuring this hole. Units with a 1/4” hole use these part numbers.
The following accessories and kits are available for single-stage snow throwers. See the retailer from which you purchased your snow thrower, an authorized Troybilt Service Dealer or phone (866) 840-6483 for information regarding price and availability Accessories & Kits For parts and/or accessories please call 1-866-840-6483, or...
NOTES: Use this page to make notes and write down important information. For parts and/or accessories please call 1-866-840-6483, or 1-330-558-7220. www.troybilt.com...
Page 20
MANUFACTURER’S LIMITED WARRANTY FOR The limited warranty set forth below is given by Troy-Bilt LLC with respect to new merchandise purchased and used in the United States, its posses- sions and territories. “Troy-Bilt” warrants this product against defects in material and workman-...
Need help?
Do you have a question about the Squall 5521 and is the answer not in the manual?
Questions and answers