Troy-Bilt Super Bronco J609 Operator's Manual page 12

NOTE: Refer to the TRACTOR SET-UPon page 7 manual for
gasoline and oil tiff-up instructions.
1. Insert the tractor key into the ignition switch.
2. Place the PTO (Blade Engage) Lever in the
disengaged (Blade Stop) position.
3. Engage the tractor's parking brake.
4. Move the throttle control lever into the CHOKE position
(a warm engine may not require choking).
5. Turn the ignitionkey clockwise to the START position.
After the engine starts, release the key. It will return to
the ON position.
IMPORTANT: Do not hold the key in the START position for
longer than ten seconds at a time. Doing so may cause
damage to your engine's electric starter.
6. After the engine starts, move the throttle control lever
from CHOKE to the FAST position.
NOTE: Do NOT leave choke control on while operating the
tractor. Doing so will result in a "rich" fuel mixture and
cause the engine to run poorly.
the Engine
WARNING:
If you strike a foreign object, stop the
engine, disconnect the spark plug wire(s) and ground
against the engine. Thoroughly inspect the machine for any
damage. Repair damage before restarting.
1. If the blades are engaged, place the PTO lever in the
"Blades Stop" position.
2. Turn the ignition key counterclockwise to the OFF
position.
3. Remove the key from the ignition switch to prevent
unintended starting.
Dr[v[n Tractor
Depress the brake pedal to release the parking brake.
Move the throttle lever into the FAST (rabbit) position.
To move forward, place the shift lever in the FORWARD position, then slowly depress the drive pedal until the
desired speed is achieved. To move in reverse, place the shift lever in the REVERSE position, check that the
area behind is clear then slowly depress the drive pedal.
DrivingOnSlopes
IMPORTANT: Refer to the SLOPE GAUGE on page 6 to help determine slopes where you may operate the tractor safely.
Mow up and down slopes, never across.
Watch for holes, ruts, bumps, rocks, or other hidden objects. Uneven terrain could overturn the machine. Tall
grass can hide obstacles.
Avoid turns when driving on a slope. If a turn must be made, attempt while going downward on the slope.
Avoid stopping when driving up a slope. If it is necessary to stop while driving up a slope, start up smoothly and
carefully to reduce the possibility of flipping the tractor over backward.
The following information will be helpful when using the cutting deck with your tractor.
12