Troy-Bilt Super Bronco J609 Operator's Manual page 22

After replacing the drive belts, adjust the drive
pedal on your tractor as follows:
1. Locate the speed control assembly on the
underside of the steering support bracket. See
Figure 18. Return
2. Remove both hairpin clips from the pin which is
fastened to the speed control assembly (be careful
not to lose the small flat washers found on the pin). Hair
See Figure 18. ,,,_Clips
3. Remove the drive pedal return spring.
4. Using two 9/16" wrenches, remove the pin from the
speed control assembly. See Figure 18.
5. Thread the idler adjustment rod inward or outward
to lengthen or shorten the travel of the double-idler
bracket until proper adjustment is achieved.
6. Reassemble by following the above steps in
reverse order.
Idler Place Wrenches Here
AutoDrive '_Pedal
Return Spring
Speed Control
Assembly
Figure 18
SECTION 8: OFF-SEASON S TORAGE
_bb WARNING:
Never store the machine or fuel container indoors where there is an open flame, spark or
pilot light such as on water heater, furnace, clothes dryer or other gas appliance.
Clean and lubricate the tractor as instructed on page 15 before storing for an extended period.
_WARNING:
Drain fuel only into an approved container outdoors, away from an open flame. Allow engine
to cool. Extinguish cigarettes, cigars, pipes, and other sources of ignition prior to draining fuel.
Follow instructions in the Seasonal Storage section of the engine manual for proper engine care prior to storing
your tractor.
It is not necessary to remove the battery from the tractor for storage. However, clean the top fo the battery and
make sure it has full charge. Disconnect the negative terminal of the battery before storing the tractor.
NOTE: Recharge the battery before returning it to service after storage. Even if the tractors starts, the engine
charging system may not bring the battery upto a full charge, unless it is recharged.
A a@ments & Accesso bs
The following attachments and accessories are available for your lawn tractor. See your local Troy-Bilt dealer for
price and availability.
MODEL
0EM-190-116
0EM-190-180
0EM-190-603
0EM-190-604
0EM-190-607
0EM-190-822
0EM-190-823
DESCRIPTION
Mulch Kit
FastAttach
TM
Twin Bagger Grass Collector
FastAttach
TM
Grille Guard (mounts on front of tractor)
FastAttach
TM
Yard-Mate
TM
Storage Container/Toolbox (mounts on rear of tractor)
FastAttach
TM
Deluxe Tractor Sunshade
FastAttach
TM
46-inch Front Dozer Blade
FastAttach
TM
42-inch Two-stage Snow Thrower
22