Sony DAV-HDX275 Operating Instructions Manual page 3

8) Do not install near any heat sources such :ks
radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9) Do not del\:at the safety purpose of the polarized or
grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding
type plug has two blades and a third grounding
prong. The wide blade or Ihe third prong are
provided lk)ryour safety. If the provided plug does
not fit into your outleL consult an electrician for
replacement of the obsolete outlet.
10)Protect the power cord from being walked on or
pinched particularly at plugs, convenience
receptacles, and the point where they exit from the
apparatus
11)Only use attachments/accessories specified by the
manufacturer.
12)Use only with the cart, stand, tripod, bracket, or
table specified by the manufacturer, or sold with
the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to
avoid injury from tip over
• Install this system so that the AC power cord/mains
lead) can be unplugged from the wall socket
immediately in the event of trouble.
Note on power cord plug shapes
(Saudi Arabian model only)
For AC 220 V wall sockets
Make sure that the 13 A 3-pin plug (Type BF)
is securely attached to the power cord. (The 13
A 3-pin plug is attached when shipped from the
factory.)
For AC 127 V wall sockets
1
Remove the 13 A 3-pin plug using a
screwdriver.
13)Unplug this apparatus during lightning storms or
when unused for long periods of time.
141Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate
normally, or has been dropped.
Note to CATV system installer:
This reminder is 1)rovided to call the CATV system
installer_s attention to Article g20-40 of the NEC that
provides guidelines lk)r proper grounding and, in
parlicular, specifies that the cable ground shall be
connected to the grounding system of the building, as
close to Ihe point of cable entry as practicah
Precautions
On power sources
•
AC power cord (nladns lead) must be changed only at
the qualified service shop
• The unit is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet ImainsX even if Ihe unit itself has been turned
off
2 Attach the supplied parallel blade plug (Type
A).
3 GB