Sony KDP-51WS550 Operating Instructions Manual page 27

VCR and Cable Box
For best results, usethis connection if:
n Your: cable company scrambles some channels, such as promium
channels (which requires you to use a cable box), but does not
scramble all channels.
=_iiiIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
Withthis connection, youcon useall thedualpicturefeature_
With this connection you can:
El Use the TV remote control to change channels coming through
the cable box. (You must first program the remote control for
your specific cable box; see "Programming the Remote Control"
on page 49.)
E] Use the TV remote control to change channels coming directly
into the TV's CABLE jack. (The TV's tuner provid es a better
signal than the cable box.)
E] Record channels coming through the cable box and channels
coming directly into the TK
Toconnect a VCRand cable box, you need:
El A splitter, which is a small, inexpensive device that you can
purchase at your local electronics store.
Three coaxial cables.
One AiV cable or one S VIDEO cable with audio cables.
Toconnect the VCRand cable box
1
Connoct the CATV cable to the single (input) jack of the splitter.
2 Use a coaxial cable to connect one of the splitter's two output
jacks to the TV's CABLE jack.
3 Use a coaxial cable to connect the splitter's other: output jack to
the cable box's input jack.
4 Use a coaxial cable to connect the cable box's output jack to the
VCR's RF input jack.
5 Use an AiV cable to connect the VCR's AiV output jacks to the
TV's AiV input jacks.
6 Use a coaxial cable to connect the VCR's RF output jack to the
TV's VHFiU HF jack.
7 Run the Auto Setup program, as described in "Setting Up the
Channel List _' on page 41.