Sony KDP-51WS550 Operating Instructions Manual page 50

Programming the Remote Control
The remote control is preset to operate Sony brand video equipment.
-N
i,L[NK i.L[NK/AV1 901
8 mm VCR AV2 302
VHS VCR AV3 301
DVD player DVD Z51
If you have video equipment other: than Sony brand that you want to
control with the TV's remote control, use the following procedure to
program the remote control.
Turn to the list of "Manufacturer's Codes" on page 50, and find
the throe-digit code number: for the manufacturer of your
equipment. (If more than one code number is listed, use the
number: listed first.)
Opcm the remote control and set the AiV slide switch to i.LINK/AVI,
AV2,AV3,or DVD. T hen close the remote control.
3 Press CODESET.
4
Enter the three-digit manufacturer's code number.
5 Press ENTER.
To check if the code number works, aim the TV's remote control
at the equipment and press the POWER button that corresponds
with that equipment. If it responds, you a m d one. If not, _:y using
another code listed for that manufactm:er.
Notes
121 Ifmore than one code number: is listed, try entcn:ing them one by
one until you come to the correct code for your equipmcmt.
121 If you enter: a new code number, the code number: you previously
entered at that setting is erased.
121 In some cases, you may not be able to operate your equipment
with the supplied remote control. In such cases, use the
equipment's own remote control unit.
121 Whenever you remove the batteries to replace them, the code
numbers may revert to the factory setting and must be reset.
49