Sony Walkman MZ-NF610 Operating Instructions Manual page 24

To Press
Record li'om the end of the Press END SEARCH, press _ while holding down RE(-' •
current contents0 T MARK0.
Record over partway Press _ or press _ or _ lo find lhe start point of
through lhe
previous
recording, and then press • lo stop.
recording0 Press _ while holding down REC • T MARK.
Pause Press 112).
Press II again to resume recording.
Remove the MD Press • and open lhe lid)) (The lid does not open while
"TOC Edit" flashing in lhe display.)
i) If "R-Posi" is sei to "Fr End", recording operations will always start from the end of the previously
recorded material wilhoul pressing the END SEARCH button (page 56).
2i A track mark is added at the point where you press I I again to resume recording while pausing; thus
the remainder of the track will be counted as a new track.
3) If you open the lid while "R-Posi" is set to "Fr[ lere", recording wil! begin from the top of the disc the
next thne you record. Check the point to start recording on the display.
If the recording does not start
• Make sure the recorder is not locked (pages
14, 20).
• Make sure the MD is no_ record protected
(pages 22, 69).
• Premas_ered MDs cannel be recorded over.
Notes
• Do not change lhe rechargeable battery during
operation even if_he recorder is connected to
AC power adaptor. The opera{ion may stop.
• "Edit" flashes while data of the recording (lhe
track's start and end points, etc.) is being
recorded. Do not move lhe recorder or
disconnect the power source while _he
indication is flashing in the display.
• If the power supply is disrupted (i.e. the
battery is removed or becomes exhausted or
the AC power adaptor is disconnected) during
a recording or editing operation, or while
"Edit" appears in lhe display, it will no_ be
possible to open the lid until power is restored.
• Note the following wben recording frmn a
portable CD player:
--Some portable CD players may not be
capable of digital out when the AC power
adaptor is disconnected, lf_is is the case,
connect the AC power adaptor to the
portable CD player and use it on AC power
as the power
SOUrCe.
_n some portable CD players, optical
output may not be possible when usthg an
anti-skip _nction (e.g., ESP* or G-
PROTECTION). If this is the case, turn off
the anti-skip function.
* Electronic Shock Protection
• The recording level is adjusted automalically.
To adjust the level mmmally, see "Adjusting
the recording level manually" (page 34).
• You can monitor the sound during recording.
Connect the headphones/earphones with
remo_e control to ,Q and adjust lhe volume by
pressing VOL L or . This does not affect the
recordthg level.
24