Sony SLV-AX20 Operating Instructions Manual page 66

2
Press 4-/,,,_ to move the pointer (V) to the point
where you want to start playback.
The VCR starts searching and the cursor (•)
moves toward the pointer. When the VCR locates
the marked point, playback starts.
7
F ......... II ........... ]
0 • " " 12_
To cancel searching
Press 12> PLAY or • STOP.
To turn off the bar indication
Press DISPLAY again.
Notes
• The figure on the bar indication represents the total time length of the inserted tape as shown
below.
The total time length may not be displayed correctly for:
- Tapes other than T-60, T- 120, or T- 160.
- Tapes recorded in more than one tape speed mode,
Total time length
Tape type
SP LP EP
T-60 or shorter 60 120 180'
from T-80 to T-Z40 120 240 360
T-160 or longer 160 320 480"
• If you move the pointer (V) on the bar indication while searching, the VCR searches for the
new reset point.
• With the bar indication on, the _ _ FF/_ and _ _ REW/_'- buttons on the remote
work only for moving the pointer (XT).while the _ _ FF and _ _ REW
buttons on the VCR are used for normal tape operation. Note, however, if you press these
buttons on the VCR, searching is canceled.
66
Searching for a selected point on the tape (SLV-N60/AX20 only)