Soleus Air PH1-12R-03 Owner's Manual page 15

WATER DRAINAGE
When the unit is in cooling mode, unwanted water is extracted from the air. Most of this water is used to cool
the unit and make it run more efficiently. When the unit is used in extremely humid environments, water will
collect in a water container at the bottom of the unit. When the water container is full, the compressor will
stop but the fan will continue to run.
When the water container is full, the unit will display 'FULL' on the control panel until the tank is emptied.
To resume operation, empty the water container according to the following steps:
Turn the unit off. Do not move the unit when the water container is full.
,
2.
3.
Place the drain pan accessory under the drainage port at the back of the unit.
Remove the rubber plug from the drain hole. The condensate water will drain out automatically.
When the drain pan is full, replace the rubber plug into the drainage hole to stop the water flow.
Empty the drain pan. Repeat until all the water is emptied.
Once the water container has been emptied, replace the rubber plug into the drain hole firmly. Do not
allow the water to drip continuously into the drain pan, as it might easily overflow.
DRAINING iNTO THE DRAIN PAN CONTINUOUS DRAINAGE
NOTE: In heating mode,the drain pipe accessorymust be used to emptythe water container.
l. Remove the rubber plug and keep for future use.
2. Connect the drain tube accessory to the drain hole. Place drain pan at end of drain tube; water will
drain out automatically during operation.
15