Cutting Height Adjustment - Snapper NZM19482KWV Safety Instructions & Operator's Manual

Section 3 - OPERATING INSTRUCTIONS
3.3 CUTTING HEIGHT ADJUSTMENT
1. Adjust cutting height, as desired, to any position,
using deck lift lever. The release latch should be
pulled up when lowering the deck. When raising the
deck, the release latch does not have to be pulled
up. IMPORTANT: There is a foot assist pedal
located to the right front side of the footrest. Always
use this assist pedal to raise or lower the deck to the
desired cutting height. See Figure 3.9 & 3.10.
2. If a specific deck height is desired each time the
machine is used, insert the stop pin to desired
cutting height. See Figure 3.11.
NOTE: The engine does not have to be running to adjust
cutting height.
FIGURE 3.9
DECK LIFT
LEVER SHOWN IN
HIGH CUTTING
HEIGHT
PULL RELEASE
LATCH UP WHEN
CHANGING THE
DECK HEIGHT
FIGURE 3.11
6 HOLE POSITIONS
FOR STOP PIN
3.4 OPERATION- MOTION CONTROLS
3.4.1. DRIVING MACHINE
1. Start engine. Release parking brake.
2. Move motion control levers gently and with
caution in desired direction. See Figure 3.12.
FORWARD - Move both control levers forward.
REVERSE - Move both control levers rearward.
LEFT TURN Move left control rearward or move
right control lever forward.
RIGHT TURN - Move left control forward or move
right control lever rearward.
ZERO RADIUS TURN - Move one control lever
forward and move the other control lever rearward
simultaneously.
LEVER
SHOWN IN LOW
CUTTING HEIGHT
POSITION
DECK LIFT
ASSIST PEDAL
FIGURE 3.10
WARNING
DO NOT make turns at high speed. Slow machine
motion. Move motion control lever gently and with
caution. DO NOT make sudden changes in speed or
direction.
FIGURE 3.12
WARNING
Zero-turning the machine at any speed can result in
operator disorientation, or in operator being thrown
from the machine, Exercise extreme caution when
executing a zero-turn.
12