Table of Contents
Advertisement
Section 5 - ADJUSTMENTS
& REPAIR
Ik
DANGER
Exercise
EXTREME
CAUTION
when
making
this I
adjustment, due to close proximity of moving parts.
I
5.1
NEUTRAL POSITION ADJUSTMENTS
The motion control lever controls
the movement
and stopping of the machine.
Move the control
lever to the center
or neutral
position
to stop
machine.
Engage the parking
brake to lock the
control in the neutral position. The machine should
have no movement.
IMPORTANT:
The
machine
must
not
creep
when
the
motion
control
is
in
the
neutral
position
and the parking
brake is engaged,
1. Turn key to "OFF" position.
2. Move motion control lever to the neutral position
and engage parking brake. Refer to Figure 3.7.
3. Raise both rear wheels off the ground. Secure
machine with safety blocks.
4. Remove cover screen to expose top of hydro
pumps and linkages. See Figure 5.1.
5. Remove both fans from top of hydro pumps.
6. Disconnect
motion lever connecting
rods from
hydro pump activation assembly. See Figure 5.2.
IREMOVESCREEN
FIGURE 5.1
7. Turn key to start position and start machine.
Move engine speed control to the Rabbit "FAST"
position
8. With
operator
properly
seated,
disengage
parking brake.
9. Both wheels should not have any movement, not
rotating.
10. If wheel(s) are rotating, loosen the hydro pump
activation assembly retaining screw. Move activation
assembly forward or rearward to stop rotation of
wheel. Retighten retaining screw. Repeat this step for
other hydro pump. See Figure 5.3.
11. Stop engine.
REMOVE MOTION CONTROL
LEVER CONNECTING
ROD
HYDRO PUMP
ACTIVATION
ASSEMBLY
FIGURE 5.2
MOVE ACTIVATION
ASSEMBLY
REARWARD
OR
FORWARD
TO ACHIEVE
FIGURE 5.3
LOOSEN ACTIVATION
ASSEMBLY
RETAINING
SCREW
(Continued
On Next Page)
19
Advertisement
Table of Contents
